                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1000713
Mini Track Loader RC by Zedpi is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

**MINI TRACK LOADER RC**

This is a Mini Track Loader RC like BobCat vehicle.  
Simple to print and simple to assemble, this Loader works with:  
- 3 Turnigy TS541A  
- rx Frsky V8fr-ii (or same sizes)  
- Lipo 1s2p 480mAh
- chain track Lego *NEW STL OF PRINTABLE CHAIN TRACK* (Lego number : 43903)
- some M3 screws  
   
One servo for Arm and two modified servo for both chains tracks. To convert your both servos driving, you juste need to cut the principal axis like the picture.  

Enjoy!  

https://www.youtube.com/watch?v=_hdVqqwfJ84

# Print Settings

Rafts: Doesn't Matter
Supports: No
Infill: 15%

Notes: 
Don't print the parts like STL's views.