测试固件2.1.5 beta 2

This is the latest beta firmware of OverLord and OverLord Pro.
Be careful when you try this firmware! It is not fully tested and may damage your printer.
However it refines many aspects including the auto level, manual level, edge warp, OLED stuck, resume print ,and so on.

If you have some ideas or some feedbacks, please feel free to contact us.

Our firmware will be open-sourced in the late fall. And before that we will try our best to improve the software and tidy up all the code~



Note: After update, please do Factory Reset.

Overlord Version 2.1.5 beta 2:
https://github.com/jimaobian/OverlordFirmware/raw/master/Version%202.1.5M%20-beta%202.hex

Overlord Pro Version 2.1.5 beta 2:
https://github.com/jimaobian/OverlordFirmware/raw/master/Version%202.1.5P%20-beta%202.hex

Update List:

Refine Resume Print ("SD search Too long")
Fix the OLED screen offset
Fix the time display during printing
Fix the OLED Frozen problem
Refine the Auto Level
Refine the Manual Level
Fix the bed cannot heat in some rarely condition

:dizzy:看着好晕

丄帝De咗臂 发表于 2015-6-18 14:22
看着好晕

修改后，感觉好些了吗？

Rockets 发表于 2015-6-27 12:41
修改后，感觉好些了吗？

好棒，很清晰啦