8139| 0
|
Bluno M3 GPIO |
本帖最后由 dwblinux 于 2015-1-5 09:29 编辑 目录: 概述 GPIO 模式 GPIO 参考函数 参考例程 1.概述 Bluno M3是非常容易使用通用输入/输出数字IO口,GPIO端口是从数字0到38。 2.GPIO 模式 每个GPIO管脚都可以通过 pinMode()配置成数字输出或者输入等。 3.GPIO 参考函数 pinMode() digitalRead() digitaalWrite() 4.参考例程 /* Blink Turns on an LED on for one second, then off for one second, repeatedly. This example code is in the public domain. */ // Pin 13 has an LED connected on most Arduino boards. // give it a name: int led = 13; // the setup routine runs once when you press reset: void setup() { // initialize the digital pin as an output. pinMode(led, OUTPUT); } // the loop routine runs over and over again forever: void loop() { digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level) delay(1000); // wait for a second digitalWrite(led, LOW); // turn the LED off by making the voltage LOW delay(1000); // wait for a second } |
© 2013-2024 Comsenz Inc. Powered by Discuz! X3.4 Licensed